This article is also available in:

How to schedule Twitter threads

To create and schedule Twitter Threads with Publer:

Go to Create page.
Select a Twitter account and start composing a new tweet.

You can add up to 4 photos, format the text as bold or italic, and generate hashtag suggestions, or even add media files. Moreover, you can prepare some bulk content with just a few clicks, by allowing the built-in Spintax Generator provide new content based on the keywords that you provide.

Tap on the Make a thread icon.

Enable: Make a thread
Then, if you want to add a delay for the first follow-up tweet, use the “Is older than” condition (formerly called "Delay") to specify when it will be posted by clicking “Add Conditions”.

From there, you can choose how long you want to delay it for.

(OPTIONAL) You can set follow-up tweets to be automatically posted based on the performance of the previous tweet. For example, a follow-up tweet can be triggered if the previous tweet engagements or reach exceed the values you specify.

NOTE: Follow-up comments can be set to post automatically based on a specific delay or performance. Conditions can be based on Time (Is older than), Reach, and Engagements.

To continue your thread, click the small + icon below the tweet: Add another post.

The second follow-up tweet can be scheduled based on the previous tweet if the specific condition is also enabled.
To add media, simply click on Click to upload media and choose the media you want to add.

NOTE: You can also set conditions for additional follow-up tweets. However, performance-based conditions apply only to the FIRST follow-up tweet.

Once you have finished creating the follow-up tweets and your thread is ready, simply click on Save and proceed with scheduling the post accordingly.

NOTE: Threads and follow-up comments do NOT carry over automatically when reusing posts from saved drafts, scheduled content, or previously published posts. Therefore, you will need to manually add them each time.

TIP : You can also set default follow-up comments or threads for all your posts by following this guide.

Keep in mind:

You can create up to 25 tweets per thread.
Each follow-up tweet is customizable text formatting tools, emojis, hashtag suggestions, and media files.
Each follow-up tweet will have a 280 character limit. Publer will highlight any text that goes over the limit.
Each follow-up tweet will get shared based on the previous tweet. For example, you can't schedule the third tweet of a thread to be posted before the second one.

Updated on: 30/09/2025

Was this article helpful?

Thank you!